Cast and Die fabrication:

By Dr. Vishaal Bhat on Wednesday 23 December 2009 with 0 comments





 cast die fabrication, Dental Material
·       Working cast and opposing cast are correctly mounted on the articulator
·       Preparation finish line is outlined in red pencil (Very fine red line) 
·       Die hardening agent is applied to the finish line area to protect it from abrasion (thin layer, less than 10 microns)
·       Die relief agent is applied on the preparation portion of the die, 0.5 mm short of the finish line
·       2 coats is usually necessary to achieve the desired 20-40 micron relief
·       Proximal contact surfaces of the adjacent teeth are lightly scraped and protected with die hardening agent.
·       Die lubricant coated over the die and allowed to soak for several minutes.


Category: Dental Materials Notes , Prosthodontics Notes

POST COMMENT

0 comments:

Post a Comment